Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! problem: slab and beams' lines don't intersect

valarhi, i couldn't solve that, used all my weapons still these lines showing, didn't understand. it should be solved. this line shouldn't show. checked: *they are in the same layer both with same number of intersection. *they are with same material....

Resolved! problem at wall corner

Hello, When I draw wall enclosure: (1) whilst when draw wall enclosure on a blank space, it fillets normally. (2) but when draw based on the basement trace reference plan, the wall corner cannot be filleted sharply, Please advice why, see picture abo...

Anonymous by Not applicable
  • 359 Views
  • 8 replies
  • 0 likes

Floor plan view beam

Hello, I would like to know how to show the entire contour of my beams. I have use them to reproduce the roff ridge (corniche) of an old school from the 40's. That corniche has gables. I would like to see lines in floor plan view where my beams are i...

Anonymous by Not applicable
  • 266 Views
  • 3 replies
  • 0 likes

How do I control how a door is assigned to which zone?

There is a zone on both sides of my doors. The door schedule reads one of the zones, but it does not seem to be the zone that has the door tag location or the door swing direction, and yet sometimes it is. I have not been able to figure out how to co...

Custom door frame size and leaf offset?

I am trying to model interior doors for a residence and am having the following goals and haven't found a way to pull it off using either the standard doors or cadimage doors. 1. There should be a wide frame or trim around the door that has a depth t...

Anonymous by Not applicable
  • 390 Views
  • 1 replies
  • 0 likes

Modify Tread in stairs tool

Hi guys, is there a way to modify the tread to whatever lenght I want in the stairs tool? I use an Italia version of Archicad 24 and the whole process is linked to a specifi formula (Italian: 2Heigh of Tread + Tread = 65): I haven't been able to modi...

Paopao by Newcomer
  • 190 Views
  • 1 replies
  • 0 likes

Didn't find the answer? Start a new discussion

Labels