About Archicad's design tools, element connections, modeling concepts, etc.

Forum Posts

wand tool correctly sees boundary but zone tool gives an error

Hi ! I have gypsum and brick walls together and I don't think material definitions somehow might harm area calculations, in other words I'm doing area calculation of premises and some (almost half) of them giving me error that boundary isn't closed.....

kosta_0-1646390198817.png kosta_1-1646390225334.png
kosta by Booster
  • 7 replies

How to have double doors to Base Cabinet Block 25

I would like to have a double doors to sink cabinets & standing cabinets yet Archicad 25 it only offers single doors with variable segment heights. Will they be introducing a 25 version of the 'Cabinet Base Double Door' & 'Cabinet tall double door' f...

Resolved! surface defaults

Hi, I have a couple of issues with surfaces that are semi-related so I will try and explain the best I can, hopefully this is the right forum to post it.I have tried looking through the help center's and forums but I haven't been able to find anythin...

Zone - Substract from zones and reduce wall area not working in AC25

Hi, I have issue with zones in Archicad 25.Actually, when the wall's relation to the zones is set substract from zones or reduce zone area only, it doesn't exclude the area of the wall, the net zone area stays the same, after updating the zone. I che...

artecon by Booster
  • 6 replies

Any chance to make those lines thinner ?

Hi ! Any chance to make those lines thinner ( image 1) ? This is symbolic view of a door, and also for windows.I really do preffer the image 2 representation which is achievable by toggling that icon as it cuts only those frame lines that are really ...

kosta_2-1646218894031.png kosta_0-1646218751475.png kosta_1-1646218813256.png
kosta by Booster
  • 7 replies

Door 3D view simplified, not MVO

Hello, I was working in plan copying a door to an exterior wall using the eye dropper tool. When I looked at the door in 3D it no longer has any detail and assumes the surface of the wall, only an outline of the opening is visible. In plan it looks c...

Window Issues

Hello Graphisoft Community, I'm discovering more and more "errors" in the programming of Archicad windows... - In the austrian Version for example, the window casing is in the floorplan and in the section not visible. - The Insulation reveal is unfot...

mbrf by Contributor
  • 4 replies

Resolved! Object is not selectable after "use fills" are turned off

Hi, Object(windows, door) becomes not selectable after "USE FILLS" are disabled from "Floor plan and Section" from settings. Is that ok behavior? I don't fint a place where to click to select them after disabling fills, even thick lines not going to ...

kosta by Booster
  • 6 replies

Resolved! Trying to Make Railing Horizontal

I'm trying to make horizontal railings for a deck however they keep making themselves sloped at the ends. I can't seem to find the setting to get the railings to not do that. Can someone suggest a solution? I'm new to Archicad but so far the good has...

Screen Shot 2022-02-25 at 9.38.49 PM.jpg Screen Shot 2022-02-25 at 9.39.18 PM.jpg