Design forum
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! problem at wall corner

Hello, When I draw wall enclosure: (1) whilst when draw wall enclosure on a blank space, it fillets normally. (2) but when draw based on the basement trace reference plan, the wall corner cannot be filleted sharply, Please advice why, see picture abo...

Anonymous by Not applicable
  • 8 replies

Floor plan view beam

Hello, I would like to know how to show the entire contour of my beams. I have use them to reproduce the roff ridge (corniche) of an old school from the 40's. That corniche has gables. I would like to see lines in floor plan view where my beams are i...

Anonymous by Not applicable
  • 3 replies

How do I control how a door is assigned to which zone?

There is a zone on both sides of my doors. The door schedule reads one of the zones, but it does not seem to be the zone that has the door tag location or the door swing direction, and yet sometimes it is. I have not been able to figure out how to co...

Custom door frame size and leaf offset?

I am trying to model interior doors for a residence and am having the following goals and haven't found a way to pull it off using either the standard doors or cadimage doors. 1. There should be a wide frame or trim around the door that has a depth t...

Anonymous by Not applicable
  • 1 replies

Modify Tread in stairs tool

Hi guys, is there a way to modify the tread to whatever lenght I want in the stairs tool? I use an Italia version of Archicad 24 and the whole process is linked to a specifi formula (Italian: 2Heigh of Tread + Tread = 65): I haven't been able to modi...

Paopao by Newcomer
  • 1 replies

Missing Accessories Objects

Can anyone shed any light on why the attached screenshot shows "Missing Roof Accessory Objects" is stated when they are loaded as per GS Support instructions? Same in all 4 accessories where they are loaded and the red text says they are missing.

Didn't find the answer? Start a new discussion