Design forum
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Survey point and modeling volume limit

Hello, Modeling in 3D (BIM or not) means modeling in a limited volume. The farther away from the original 0,0,0 point, the greater the risk of 3D aberration.With Archicad 25 I can finally import a point cloud or a dwg which can be placed very far fro...

Resolved! Floor Composite Skin Lines Not Showing

Hi All, I am trying to make a slightly detailed building section and having a strange issue with my floor composite. The composite displays the fills but not the skin lines where it is positioned in the model. Here's the weird thing (and the reason w...


Wall framing accessory question

I was trying the wall framing accessory again today, but still can't figure out how to control the location in relation to the framing cavity; it always comes in offset. Am I missing some obvious control? Is there something special that one needs to ...

Stair riser

I need to type in a specific riser height, and I have been changing all of the settings, but I can't seem to find the right one so i can only change the specific riser height. Any notes?

Screen Shot 2021-11-04 at 9.00.42 AM.png

Resolved! See Selected Element in a 2D also in 3D

Hello Everyone!I am new to Archicad and I have a question to ask please.I want to see a selected element in 2d ( which will be highlighted in green) also in the 3d view with the green highlight. Is there any option like this ?With Revit it is automat...

Rafter tails in AC24? how best to do?

I'm sure this has been hashed out many times...but I'm still not sure what is the best way to do this.I have to produce these all over the roof rafter ends. When the slope changes..I need to create "NEW" custom there an easier way to have ...

rob2218 by Booster
  • 9 replies


My computer keeps generating one facade. I have purged my library and other options.I can load everything else except my front view. Has anyone encountered this problem before, and how did you solve it ?

EliesH by Newcomer
  • 3 replies

Creating Archive PLA

I have just tried to create a PLA from AC24 6004 UKI Full and get the following warning. Library Manager isn't showing any errors, so why would I see this, and should I worry something critical could be missing?

Screenshot 2021-11-03 at 09.26.00.png

wall intersections change with structural display?

hey all,I have a problem with wall intersections when i change structural display settings. my exterior composite walls interior layers will be built at different times than most but not all of the interior walls, because it's a Passive House. so onl...

Screen Shot 2021-11-01 at 13.43.16.png Screen Shot 2021-11-01 at 13.43.37.png

Didn't find the answer? Start a new discussion