I have just released the recording of my session on creating existing
site conditions from my ARCHINTENSIVE 2020 event. I think that this
session provides users with a lot of insight into the various ways you
can create the site terrain and the pros ...
Whats the best method for showing cut and fills in ArchiCAD. Ive created
a mesh in the 'renovation' filter, and copied this to the proposed
filter. If I make changes in this, will ArchiCAD calculate and show and
cut/ fill in the demolition filter?
Hi,I've been modelling a project on a pretty complex terrain and with
some perforated bricks. Both these elements show fine in all view ports,
but when I put it on a layout they disappear. I've tried to extend the
skirt length of the mesh past the lo...
The only posts I've found are from decades ago. Yes, I can drag a single
mesh node outside of the boundary and it disappears, but only if the
node is connected to nothing. Yes, you can delete an entire contour line
ridges. Yes, you can make a hole in...
Hi,I copied a series of Concrete columns, for some reason, all the
copied columns have no Outline in Section I've looked at the pen & fill
properties, but I can't see a difference btw them. The columns are all
aligned across section. Please see attac...
Hi,I've added a mesh, and set the nodes relative to each other - taking
the lowest point as zero. Then I've set Sea Level to x.x mtrs. The
Elevation markers reflect this. Now. When (in site plan), I place a Spot
level marker on the mesh - it only sho...